Decorative sticker for furniture green

Our furniture wrap is created on a matte monomeric film, which is designed for application on flat surfaces (e.g. built-in wardrobe doors, chest of drawers fronts, cabinet sides). The wrap is self-adhesive (no glue required), making it very easy to apply. Monomeric film is characterised by its durability and high colour saturation. Thanks to modern latex printing technology, our furniture wraps perfectly reproduce the details of the chosen motif.

♦ Dimension: 100x50 cm  ♦ Material: Matte self-adhesive monomeric film 
♦ High material quality ♦ Print with perfectly reproduced details.

WET TECHNIQUE - The wet technique makes installation easier and allows for adjusting the position of the furniture wrap.

1. Pour water into a spray bottle.
2. Thoroughly clean the area where the wrap is to be placed. Dirt, dust, and other contaminants must be removed from the surface.
3. Adjust the wrap to the surface with the printed side facing up. If necessary, trim the wrap with scissors or a wallpaper knife.
4. Generously spray the surface to be covered with water.
5. Peel back approx. 5-10 cm of the backing paper and fold it down evenly. Spray the adhesive part of the wrap with water. Stick the peeled fragment, smoothing it with a squeegee to push out water and air bubbles.
6. Remove further sections of the paper, spraying the adhesive side of the wrap, and then stick by smoothing it with a squeegee.
7. Finish smoothing the wrap with the squeegee, removing all bubbles, and then dry the surface with a towel. Done!

DRY TECHNIQUE

1. Prepare the surface. Thoroughly clean the area where the wrap is to be placed. Dirt, dust, and other contaminants must be removed from the surface.
2. If you are installing the wrap on a vertical surface, start installation from the top. In other cases, it does not matter which side you start applying the print from.
3. Unroll the wrap on a clean, dry surface with the printed side up and check for any printing errors.
4. Place the wrap evenly against the surface. Peel off approx. 20 cm of the material, tuck the backing paper underneath, and then smooth the stuck fragment with a squeegee - pushing out air bubbles.
5. Finally, smooth the wrap with the squeegee, removing all bubbles. Done! 

We use state-of-the-art GreenGuard certified latex printers. This ensures the highest print quality and guarantees that the purchased wraps are health and environmentally friendly, meeting the most stringent safety standards. If you have any questions, please contact us!

We pack furniture wraps in secure cardboard tubes, so you don't have to worry about the product being delivered creased or damaged. We include step-by-step installation instructions with every wrap.

If you like the furniture wraps in our range but are not sure if they will suit your interior - write to us and we will send you material samples. Note! Samples are intended for checking the material in reality, not for comparing colours! Colours may vary slightly depending on the given print batch.